By FXLover on Tuesday, 07 July 2020
Replies 3
Likes 0
Views 2.1K
Votes 0
I am struggling to get my WC3 as quiet as my Crown, even with a shogun on its not as quiet as my crown with a Tatsu on, and yes for the same 500mm Barrell and Same FPS and same pellets.

So I figured I would "crown it up" by fitting the crown shroud parts to allow it to telescope forward a few inches.

But I cant get the rear cap off - I have tried warming it up with a hairdryer but it wont budge - any ideas?
Update 8/7/20

Applied map gas on the shroud end and the end cap came off a treat.

I have swapped all the parts of my crown onto it and its much quieter now with the little WC shroud extended - but I don't think it will ever be as quiet as the crown due to the smaller Shroud on the WC.

so I am no contemplating drilling the WC shroud with say 3X 3mm Holes at the rear of the shroud on each side.

Does anyone know if this will help quieten it down

·
4 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
Update 10/7

with a cheapo weihrauch silncer and the shroud extended its super quiet

Very Happy
·
4 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
I've been considering a Wildcat Mk 3. Will the Hugget Mk 2 shroud fit? Anyone have experience in its effectiveness?
·
4 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
View Full Post