I just received my 480cc carbon fiber bottle that I am going to install on my DreamTac.
Problem: I am unable to unscrew the air tube. I have the rifle degassed and gages read zero pressure.
I have even attempted to place a wrench on the tube to twist is off. It will not budge and I now have scarred the tube.
Question: Is it possible that when my rifle was repaired in the FX Shop did they use lock tite?
I ask because the repair was to internal o-rings i blew out when I over pressurized the rifle. While it was being repaired the new power plenum came out and I had it installed at the same time as the repair.
Anyone else experience this type of issue? If so, how did you resolve?
Problem: I am unable to unscrew the air tube. I have the rifle degassed and gages read zero pressure.
I have even attempted to place a wrench on the tube to twist is off. It will not budge and I now have scarred the tube.
Question: Is it possible that when my rifle was repaired in the FX Shop did they use lock tite?
I ask because the repair was to internal o-rings i blew out when I over pressurized the rifle. While it was being repaired the new power plenum came out and I had it installed at the same time as the repair.
Anyone else experience this type of issue? If so, how did you resolve?