hello there im in need of help please first i was shooting my impact mkii power plenum .25 and heard a pop near the pellet probe then air dumped out of barrel so at this point i fully stripped gun to find which oring had failed but everything looks in tacked even the valve and stem looks ok so regassed and tryed again get maybe 10-20 shots then same again any ideas as i dont want to send it back as had problems with previous gun so not waiting months again if it goes back its for refund .
yes I haven't a problem buying new seal kit and fitting but the valve seat are approx £45 for impact and after spending like £1800 few months ago id like this to last a little longer just hope ill get bits sent then I can have a speedy recovery if not back to sportsman gun centre she goes
I had a similar problem on my Dreamline - mine was self inflicted, as I had dry fired it to death, to try and empty all the air out, I had ruined the valve seat. I could fill it to 230 and it was ok until I started firing it then it leaked about 10 bar every 2 hours.
so 1 new valve seat later and bingo, good as new.
Luckily, for me, the DL is mega simple to strip and reassemble - I doubt the impact is very hard to deal with.
O rings kits are cheap so it wouldn't hurt to swap the lot out and bang a new valve seat and see what happens - that would only cost about £30 and is bound to fix it.
so 1 new valve seat later and bingo, good as new.
Luckily, for me, the DL is mega simple to strip and reassemble - I doubt the impact is very hard to deal with.
O rings kits are cheap so it wouldn't hurt to swap the lot out and bang a new valve seat and see what happens - that would only cost about £30 and is bound to fix it.
Am not a gunsmith, only know basics. List of videos make by Ernest Rowe covering common leaks. Scroll down page.
https://airgun101.com/index.php/video-channels/fx-airguns
O rings are a law unto themselves, never managed to spot a bad one by looking at it, normally use leak spray to give me a headsup.
Does sound like a valve stem O ring......if its going up through the transfer port and down the barrel......or could be spring based. Am not a gunsmith....but you could email FX direct, they have a support section on the website.
UK has a new distributor who are now fully trained for this, maybe call them. Sportsman Gun Centre.
USA has FX USA who can help.
Unsure where you are in the world.
Don't panic, if you have a good description of what's going on and you have stripped the gun, am sure the part with the issue can be found and sent.
G
https://airgun101.com/index.php/video-channels/fx-airguns
O rings are a law unto themselves, never managed to spot a bad one by looking at it, normally use leak spray to give me a headsup.
Does sound like a valve stem O ring......if its going up through the transfer port and down the barrel......or could be spring based. Am not a gunsmith....but you could email FX direct, they have a support section on the website.
UK has a new distributor who are now fully trained for this, maybe call them. Sportsman Gun Centre.
USA has FX USA who can help.
Unsure where you are in the world.
Don't panic, if you have a good description of what's going on and you have stripped the gun, am sure the part with the issue can be found and sent.
G
- Page :
- 1
There are no replies made for this post yet.
Be one of the first to reply to this post!
Be one of the first to reply to this post!
